1. Liberally sprinkle Greaselock™ to spill or area to be cleaned, completely covering it.
2. Allow five to ten minutes for full absorption, then sweep and discard dirty solution or rinse away.
3. For large areas use the Oreck Orbiter with the Brown Pad (for smooth surfaces) or with the Orange Brush (for rough, uneven surfaces) and agitate on the surface.
4. Sweep and discard powder or rinse away. On smooth surfaces, reuse the pad to pick up any remaining powder. Mop or hose surface if necessary.
5. For fresh stains or spills use the Greaselock™ as a dry powder.
6. For dry stains add a little water during the agitating or scrubbing stage.
7. Repeat process as necessary.

1. Vacuum floor to remove surface dirt and debris.
2. Dilute ORECK Stone Clear Bottom™ 180-240ml per 6.7pints of warm or cold water.
3. Apply to floor with a mop or sprayer and let set for five minutes.
4. Scrub with Oreck Orbiter using the Orange Brush.
5. Absorb excess solution and dirt with wet/dry vacuum or mop.

1. Surface must be clean and free from grit and debris and remain dry for 24 hours prior to and after application.
2. Completely wet the surface by spraying ORECK Rock Solid™ onto the area, and agitate with the Oreck Orbiter using the Orange Brush.
3. If excess remains on the floor after five minutes, wipe off with a cloth.
4. If the surface absorbs all of the sealer after five minutes, reapply, wait another five minutes, and wipe off.
5. Allow three hours after application before walking on the surface.

• Do not store Orbiter with brushes attached as it will deform them.
• If brushes become deformed they can be rejuvenated by placing them in a tub of very hot water.
• The powder will eventually clog the pores in the vacuum bag, so remember